Error creating PDF file
Document Actions
Bus Cable
| Author: | Sébastien Lelong, The SirBot Project, 2006 |
|---|
| Revision: 1.2 | Initial creation |
| Revision: 441 | Convert into REST |
| $Revision: 594 $ | new connector specification (one for each PORT A/B) |
- Abtract
- The Bus Cable is able to connect different boards, using connection specification. No need to think about which wire needs to be connected where, just plug...
Electronic diagram
No diagram, the Bus Cable is just two connectors with wires (in layer). Connectors can be added between extremities.
Since then new mainboard version, there's now two connectors, one for PORTA one for PORTB:
 |
 |
Previous cable version used 2x13 pins connector. Now, these are 2x5 pins, which makes the cable easier to build. You can even buy some from electronic supplier, as this type of connector is used for ATMEL microcontrollers programming.
